|
EMDIN INTERNATIONAL CORPORATION
15841 BUSINESS CENTER DRIVE
IRWINDALE, CA 91706, USA
TEL: 626-813-3740 FAX: 626-445-5233
SECTION I
Product: Maxifilm
Date Issued: 1-April-2008
Chemical Family: Proprietary
Formula
SECTION II - HAZARDOUS INGREDIENTS
Materials: Isopropyl
Alcohol, water, glycerine.
Additives are proprietary in nature.
When used within the normal guidelines specified, they will
not impose any health or safety hazard.
SECTION III - PHYSICAL DATA
Solubility in Water: 100
Percent
Specific Gravity: 0.79
Appearance and Odor: Red
clear liquid, Alcoholic odor
Boiling Range: 78
deg. C
Vapor Density: 2.1
(air=1)
Evaporation Rate: 3
(BUTYL ACETATE=1)
SECTION IV - FIRE AND EXPLOSION
HAZARD DATA
DOT Category: Flammable
liquid; Flash point 55 degrees F.
Unusual Fire and Explosion Hazards: Flammable
Liquid
Extinguishing Media: Carbon
Dioxide foam, Water
SECTION V - HEALTH HAZARD DATA
Threshold
Limit Value: 400
ppm
Effect of Overexposure: Vapors and
mists causes irritation of nose and throat. Inhalation of
higher concentration may cause headache, dizziness, drowsiness,
nausea, vomiting and coma. Vapors will irritate eyes and brief
contact may dry the skin or cause burning and stinging sensation.
Emergency and First Aid Procedures:
Irrigate eyes with water
SECTION VI - REACTIVITY DATA
Stability: Stable
Incompatibility: Strong
oxidizers, alkalies, acids, amines, aluminum, chlorine, anhydrides,
aldehydes, isocyanates, helogens and helogen compounds.
Hazardous decomposition and polymerization: Will not
occur.
SECTION VII - SPILL OR LEAK PROCEDURES
Spill Procedure: Dilute
with water and wipe with cloth.
Waste Disposal Method: Incinerate
or as local laws permit.
SECTION VIII - SPECIAL PROTECTION
INFORMATION
Ventilation: Use
sufficient ventilation.
Protective Gloves: Yes
Eye Protection: Yes
Respiratory Protection: Yes
SECTION IX - SHIPPING REGULATIONS
FOR HAZARDOUS MATERIAL
Consult D.O.T. regulations.
SECTION X - SPECIAL PRECAUTIONS
The product contains alcohols. Take
all precautions normally recommended for Isopropyl alcohol.
Keep away from heat, sparks, and flames. Store in a cool,
dry, well ventilated place away from incompatible materials.
Vent container frequently, and more often in warm weather
to relieve pressure. Electricall ground all equipment when
handling this product and use only non-sparking tools. Keep
container tightly closed when not in use.
Do not use pressure to empty container.
Wash thoroughly after handling.
Do not get in eyes, or skin, or on
clothing.
Do not cut, grind, weld, or drill
on or near this container.
Containers, even those that have been
emptied, will retain product residue and vapors. Always obey
hazard warnings and handle containers as if they were full.
|